News Details
Operation steps of Guanhang manual handling vehicle
Operation steps of Guanhang manual handling vehicle
Guanhang manual handling vehicle is a common logistics equipment used to transport goods in warehouses, factories, and logistics centers. It usually consists of a pallet jack and a handle, which is operated to control the lifting and movement of the pallet jack. The following are the operating steps for manual handling vehicles:
1. Find the release lever: First, stand behind the manual pallet truck, as this is the position you are in when moving the pallet truck. Then, find a small lever that allows the tray lifting fork (a large flat metal plate near the floor) to descend all the way to the floor. The lowering rod of a pallet jack is usually a small rod located in the middle of a circular handle on the vertical pole of a manual machine. It can be distinguished by different colored plastics, marked in other ways, or not.
2. Push the descent bar inward to lower the tip: If the forks have been completely lowered, you will not see them move. At this point, it is necessary to push the descent bar inward so that the fork is only one or two inches away from the floor.
3. Place the fork under the slide rail or tray: When the fork is low off the ground, approach the slide rail and observe if the product fits underneath. If the product is not suitable, it indicates that the machine has not been sufficiently lowered, so it is necessary to push the lowering rod again.
4. Use the handle to lift the tray jack: When the fork is under the slide rail, pull the vertical rod diagonally towards you, away from the tray and towards the floor. You should feel the tray jack (and tray) rise slowly against gravity.
5. Check to ensure that the pallet jack is not on the crossbeam of the slide rail, and the front wheels must be on the floor: Before moving the manual pallet handling vehicle, it is necessary to ensure that the pallet is lifted from the floor. At the same time, it is necessary to check whether the pallet jack is not stuck on the cross wood of the slide rail, and whether the front wheels are on the floor. If the wheel gets stuck on the crossbar, it will prevent the jack from rising and also prevent it from rolling.
6. Mobile manual pallet handling vehicle: When the pallet appears and feels fully lifted so that it will not be dragged, pull the pallet jack handle to move the lifted pallet in any direction. Alternatively, when it is necessary to move the pallet upwards onto the lift gate or truck, the user can push the pallet.
By following the above steps to operate the Guanhang manual handling vehicle, it is possible to effectively handle goods and improve work efficiency. However, when using manual handling vehicles, it is necessary to pay attention to safety operating procedures to avoid accidents.