News Details
Manual hydraulic truck handle installation method
AC pouring cylinder handle installation steps
The first step is to insert the shaft with holes, the second step is to thread the chain, it should be noted that the chain must pass through the center hole of the shaft with holes; the third step is to pass the chain through the pin shaft hole; the fourth step is to clamp Chain, it should be noted that the nut at the bottom end of the chain is stuck at the concave and convex opening of the screw; the fifth step is to pull out the small iron rod that fixes the spring; the sixth step is to fix the elastic pin with a hammer.
Installation steps of split cylinder handle
The first step is to use a tool to open the screw, the second step is to insert the handle into the handle hole and tighten the screw to secure it, the third step is to pass the chain through the center hole, and the fourth step is to snap the chain into the sway bar notch place.
After the handle of the manual hydraulic truck is installed, it needs to be lifted and lowered several times to check whether there is a neutral position when the fork is rising, and whether there is a falling too fast, too slow, shaking, etc. when falling. If there is no abnormality, it proves that the handle is installed correctly and the truck can be used normally.
